SuperLift 4.5 inches Suspension Lift Kit for 1989, 1990 Ford Bronco II 4WD

SuperLift 4.5″ Suspension Lift Kit for 1989-1990 Ford Bronco II 4WD

$632.00

Found a better price?
SKU: K398 Category: Brands: .

Product Description

SuperLift 4.5″ Suspension Lift Kit for 1989, 1990 Ford Bronco II 4WD

Part: K398

  • Pre-set replacement coil springs provide lift
  • Axle pivot brackets, constructed of .25″ thick steel plate, correct camber angle
  • Sway bar brackets included
  • Caster angle corrected with Standard Series plate steel radius arm brackets or Superunner long-arm radius arms
  • Dropped pitman arm reduces steering linkage angles; optional Superunner replacement steering linkage system available.
  • Superide shock absorbers included
  • Lifetime Warranty
  • Satisfaction Guarantee

Tire and Wheel Info

31 x 10.50

IMPORTANT DISCLAIMER: The provided tire/wheel fitments are approximate.

Actual dimensions of a given tire size can vary considerably from one brand to another.

Manufacturers’ wheel offset and backspacing measurement points are not always consistent.

Backspacing greatly impacts tire-to-fender clearance when turning.

Wheel width and backspacing influence whether the tires protrude past the fenders, and to what extent.

Considering these important factors, we recommend that you fit-check your tire/wheel selection prior to purchasing.


Installation Notes

Optional extended length brake hoses recommended.

1985-90 models with tulip type rear driveshaft (has 2 rubber boots) must convert to exposed joint shaft, available form Ford.

Superunner steering must not be used on lifts in excess of 6″.


Installation Instructions


Product Overview

New pre-set coil springs provide front lift; lift blocks raise the rear. A replacement pitman arm relieves drag link angle.

Axle pivot brackets, laser-cut from .25″ steel plate, lower the inboard ends of the axle beams and restore camber. New camber alignment bushings, available from your local alignment shop, may be required to precisely “dial-in” camber angle; this need varies from one vehicle to the next.

There are two methods for correcting caster angle. Our Standard kit features brackets that lower the factory radius arms at their frame (rear) end attaching points, while our Superunner kit features replacement radius arms.

The lift kit includes front and rear Superide shocks.

The optional Superunner Steering System conversion is recommended for optimal driveability. Poly radius arm bushings are included in the Superunner kit, and a recommended option for the Standard kit.


Fitment Table

Year RangeMakeModelDrivetrainEngineCab
1989-1990FordBronco II4WD

Questions and answers of the customers

There are no questions yet, be the first to ask something for this product.

Send me a notification for each new answer.

Reviews

There are no reviews yet.

Be the first to review “SuperLift 4.5″ Suspension Lift Kit for 1989-1990 Ford Bronco II 4WD”