6 inch GM Suspension Lift Kit - 2007-2013 1500 2WD with Front Strut Spacer -K934
SuperLift 6 inch Lift Kit for 2007-2013 Chevy-GMC 1500 2WD - K934 - view 1SuperLift 6 inch Lift Kit for 2007-2013 Chevy-GMC 1500 2WD - K934 - view 2SuperLift 6 inch Lift Kit for 2007-2013 Chevy-GMC 1500 2WD - K934 - view 3

SuperLift 6″ Lift Kit for 2007-2013 Chevy/GMC 1500 2WD


Found a better price?
SKU: K934 Category: Brand:

Product Description

6″ GM Suspension Lift Kit – 2007, 2008, 2009, 2010, 2011, 2012, 2013 1500 2WD with Front Strut Spacer

Part: K934

  • Replacement knuckles yield the best possible alignment specs, and factory turning radius is retained.
  • High clearance, one-piece crossmembers, and all other load bearing bracketry, is laser cut from .25″ thick plate steel. No differential trimming required, plus the factory front drive shaft is retained.
  • Skid plate connects and strengthens the front / rear crossmembers while protecting the differential.
  • Kicker braces further increase overall rigidity.
  • Limited Lifetime Warranty
  • Satisfaction Guarantee

Tire and Wheel Info

33 x 12.50 tire on a minimum of a 18″ diameter wheel that is 8.5″ wide with a 4.5 to 5.5″ backspacing. – CAN NOT RUN STOCK 17-18″ WHEEL

IMPORTANT DISCLAIMER: The provided tire/wheel fitments are approximate.

Actual dimensions of a given tire size can vary considerably from one brand to another.

Manufacturers’ wheel offset and backspacing measurement points are not always consistent.

Backspacing greatly impacts tire-to-fender clearance when turning.

Wheel width and backspacing influence whether the tires protrude past the fenders, and to what extent.

Considering these important factors, we recommend that you fit-check your tire/wheel selection prior to purchasing.

Installation Notes

Not compatible with Denali and Escalade.

Fits vehicles w/o Electronic Controlled Shocks

Installation Instructions

Product Overview

Front lift is achieved by installing spacers on top of the factory coil-over shock assembly. Pre-load rings, installed below the coil springs, slightly increase spring rate to help offset the additional loads created by running larger tires, and firms-up what would otherwise be a “spongy” ride. The factory upper control arms are retained and remain in their original location, while the factory lower control arms and axle housing are lowered, in relation to the frame. New Superlift replacement steering knuckles, made of cast ductile iron and machined in-house, span the increased distance between the control arms.

Superlift’s geometry, from steering timing to linkage angles yield optimal component service life and exceptional drivability.

Our lower control arm crossmembers are a one-piece, full-width, high-clearance design made of .25″ steel plate, joined together by a belly pan and further reinforced by kicker braces.

Rear lift is via a 5″ rear block and u-bolt kit.

The kit is packaged complete with rear Superlift Superide or Superide SS shocks by Bilstein.

Fitment Table

Year Range Make Model Drivetrain Engine Cab
2007-2013 Chevy/GMC 1500 Pickup 2WD

Questions and answers of the customers

There are no questions yet, be the first to ask something for this product.

Send me a notification for each new answer.

Customers' review

5 stars 0 0 %
4 stars 0 0 %
3 stars 0 0 %
2 stars 0 0 %
1 star 0 0 %


There are no reviews yet.

Be the first to review “SuperLift 6″ Lift Kit for 2007-2013 Chevy/GMC 1500 2WD”

Use one of the allowed file type: jpg,png.